Online Documentation: Configuration Manual
How to use the Attached Qty (to a Traveler) in a Calculation?
Suppose you want to do a yield calculation and show the cummulative yield compared
to the part quantity of the Lot at the first step. In this case you have to configure
the system so that when the lot passes through the first step it stores the Quantity
of the attached number of parts.
The following figure shows a Step by Step description on how to add this Attached Qty
'Name-Value Pair' to the list of the Step Definition.
When Data Entries (Name Value Pairs) are added to the Name-Value Pairs Listbox, the Seq
is set by default at 10. To change the position of how the value will eventually will show
up on the Traveler you can edit the sequence numbers. In the following figure it is shown
how the new entered value is moved to the bottom of the list, and now it will be at the
bottom of the Data Entry section on the Traveler when it opens.
To have the new sequencing take effect, close and reopen the traveler (refreshing the
Traveler will not do the job)
Useful Links
How to Add and Configure Data Entries
General Step Definition Page