EZ-MES Demo: Automated Chip Testing
Moving a Traveler
The following describes step by step how to move a Traveler after the
Traveler is created and moved to active. (How to create a traveler?)
In this case the traveler is designed according to FR100116-R1.
On this page the following steps are shown:
- Creating parts on the Traveler
- Adding a Lot Number to the Created Parts
- Move the Traveler to the Next Step
1 Create the Parts on the Traveler
The parts that need to be tested are not yet in the EZ-MES system. So we
first have to create them. The following figure shows the steps needed to
create the parts:
2 Assign a Lot Number and move to Next Step
The following figure shows the step to assign a Lot Number to the attached
Lot. The Lot Number is defined to be Unique, this means that no other lot in
the EZ-MES system will be able to have this Lot Number. When you by accident
try to assign an existing lot number to a new Lot, the system will not allow
you to enter that number. The field will turn red and the entered value will be
deleted.
After the Lot Number is assigned the Traveler moves to the first Test Step.
If you forgot to fill out the Lot Number you will be notified that required information
is missing.
3 Next Step
When successful the form will change to show the data entries that are needed
to complete the next step. Fill out the data and press the 'Done' button.
Keep repeating this until the traveler is finished.
Back to the main page